Introduction:

 

  1. Hardened gear reducer mainly includes parallel shaft series and vertical axis series. The parallel shaft reducer is produced according to national standards and the product is optimized.Vertical shaft reducer is produced according to national standards. For the transmission of the input shaft and the output shaft in the vertical direction. It mainly includes three series of DBY, DCY and DFY.
    hard tooth surface parallel shaft reducer
    hard tooth surface parallel shaft reducer

 

  1. Hard tooth surface parallel shaft reducercenter distance. The main parameters such as the nominal transmission ratio are optimized, the main zero, the parts - the good changeability, the gears are made of high-quality alloy steel by carburizing, quenching. The tooth surface hardness is 54-62HRC.

 

  1. Thehard tooth surface parallel shaft reducer is small in size, light in weight, high in precision, large in carrying capacity, high in efficiency, long in life, high in reliability, stable in transmission and low in noise.

 

  1. Hard tooth surface parallel shaft reduceris generally lubricated with oil pool. Natural cooling, when the thermal power can not be met, you can use circulating oil slip or fan. The cooling coil is cooled.

 

  1. Hard tooth surface parallel shaft reducercan be widely used in metallurgy, mining, chemical, building materials, lifting, transportation, textile, paper, equipment, plastics, rubber, engineering machinery, energy and other industrial sectors.

 

hard tooth surface parallel shaft reducer
hard tooth surface parallel shaft reducer
  1. Hard tooth surface parallel shaft reducer application range: input speed is generally n, ≤1500r/min; gear transmission peripheral speed is not more than 20mis; working environment—40_50~'C. If it is below 0 ° Lubricating oil should be preheated to above 0 °C before starting. The reducer can be used in both forward and reverse directions.

 

  1. The nominal input power P of the row-shaft series gearbox. According to the load, the working time per day is less than or equal to 10h, and the starting time is no more than 5 times per hour. The allowable starting torque is twice the working torque. One-way operation, the contact strength safety factor of a single pair of gears is about 1, and the failure probability is less than or equal to 1%.

 

With Best Regards,

Candy Hao ( Sales Department; Miss. )   

NER GROUP CO.,LIMITED

Yantai Bonway Manufacturer Co., Ltd                                      

Tel:+86-535-6330966

Mobile:+86-15192224647

https://www.guomaodrive.com

https://twitter.com/gearboxmotor

https://www.facebook.com/sogears1993

Viber/Line/Whatsapp/Wechat: 008615192224647

E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.; Skepy ID:candy_4681

Add:No.5 Wanshoushan Road Yantai city Shandong Province, China(264006)